Infinity Code Forum — Polygones in overlay mode with border thickness

Re: Polygones in overlay mode with border thickness

2017-07-17T14:22:27Z

No, the thickness of the line does not depend on the zoom level.
It is the same for zoom = 20 and zoom = 3.
If you want to make the thickness of the line depend on the zoom level, just change it when changing the zoom.

Re: Polygones in overlay mode with border thickness

2017-07-17T14:13:56Z

My first polygon actually covers two streets in a village in lausanne but if I zoom in on my zoom 1, my polygon will cover all of Switzerland and part of France
Normally the border thicknes must also be updated according to the zoom of the Map right?

Re: Polygones in overlay mode with border thickness

2017-07-17T13:33:53Z

Hello.

I looked at your screenshots, and do not see the problem.
I think this works correctly.
Due to small size of the polygon and the thick border, you see just a circle.

Re: Polygones in overlay mode with border thickness

2017-07-17T10:01:19Z

This reply for the second capture in the zoom 1( polygone 1 is blue: the color of his border / plygone 2 is the red one with border in green)

Polygones in overlay mode with border thickness

2017-07-17T09:59:36Z

I have a problem with polygones in overlay mode.
I make two polygones in Switzerland :
* 1 polygone in Lausanne (town in switzerland) that covers two streets in this village with a border_thikness=15.
* 1 polygone which covers almost half of Switzerland with border_thikness = 1

In zoom= 18 (zoneBug_1.png : exemple of the polygone 1 ), no problem, but if I zoom out to zoom = 1 I will have my polygone1 that covers all of Switzerland and part of France while the other zone is still valid (zoneBug_2.png

You will have the second capture in the next reply