• Registered: 2019-05-22
  • Posts: 3

Topic: Scaling bug meters to scale and reverse

Hi,
I need to be able to switch the scale of my 3D markers to meters and update that correctly on demand.
However, if I currently adjust it from scale to meters, it makes the prefab slightly smaller. But if I adjust the scale number, it becomes way smaller, which seems the correct size.
https://streamable.com/xk0d9

It only updates when I change the scale float. I cannot find anywhere in the code where I can force it to update the scale. Is there a way to do this?
I tried:
OnlineMaps.instance.Redraw();
But that throws all my scale adjustments away
I also tried marker.Update();
But that does not seem to do anything.

Is there anything I can do for this?



PS: Also, the scale of Marker A seems to adjust the scale of marker B someway. I'm not sure why this happens. Do you know anything for that?
(See attached video)

2 Reply by AmberElferink (edited by AmberElferink 2019-06-03 12:58:14)

  • Registered: 2019-05-22
  • Posts: 3

Re: Scaling bug meters to scale and reverse

I cannot see the attached video now I posted it. I'm posting a link to it just to be sure: https://streamable.com/9owr8
(little bit incovenient you can only post 1 link per post).
Important to notice, if I call OnlineMaps.instance.Redraw(); it seems to draw everything in that large mode again. No matter that the marker.SizeType still all are set to meters. Maybe it has something to do with that, although I could not find why myself.

  • Registered: 2015-06-23
  • Posts: 3,778

Re: Scaling bug meters to scale and reverse

Hello.

Thank you for the bug report.
The problem has been fixed.
The new version will be available through the built-in update system in 24 hours.

Kind Regards,
Infinity Code Team.

Boost your productivity a lot and immediately using Ultimate Editor Enhancer. Trial and non-commerce versions available.